bend radius การใช้

• Bend radius is determined by material elasticity rather than tool shape.
• The " bend radius " refers to the inside radius.
• Eliminating multi-layers guarantees a uniform bend radius across each conductor.
• Inside buildings a bend radius as low as 200 cm is allowed.
• The formed bend radius is dependent upon the dies used, the material properties, and the material thickness.
• The minimum bend radius is 250 cm for underground pipes, but 300 cm is the most commonly used radius.
• The bend radius may also be increased, and tight bends can potentially crack or tear the insulation and sheathing.
• The development of " reduced bend radius " fiber in the mid-2000s, enabled a trend towards smaller cables.
• Some cables have requirements for minimum bend radius or proximity to other cables, particularly power cables, to avoid crosstalk or interference.
• Because active cables can facilitate thin cable gauges, a tighter bend radius results, which can give cables in these applications better routability and improved airflow.
• Students learn to calculate bend radius, conductor size, conductor type for a specific location, circuit protection, box fill and maximum number of conductors in a raceway.
• For cyclic electron accelerators, a limit on practical bend radius is placed by synchrotron radiation losses and the next generation will probably be linear accelerators 10 times the current length.
• Cables must not be bent below their minimum bend radius, which depends upon cable size as expressed in AWG . The table on the right summarizes minimum values typically admitted for SFP + sustained bend radiuses.
• Cables must not be bent below their minimum bend radius, which depends upon cable size as expressed in AWG . The table on the right summarizes minimum values typically admitted for SFP + sustained bend radiuses.
• Optical fiber cables can be installed in buildings with the same equipment that is used to install copper and coaxial cables, with some modifications due to the small size and limited pull tension and bend radius of optical cables.
• The dimensions of capacitors in the low-and high-pass filters are chosen to avoid resonances near the drive frequency . ( 3 ) The microwave bend radius has a minimum value of three times the stripline width.